Custom Angled Rafter Tail Mount for UniFi UVC-G6-Pro-360 (Parametric)

Made-to-order angled rafter tail mount for the Ubiquiti UniFi UVC-G6-Pro-360. Choose your exact roof pitch (level through 12/12) and extension length (2.5" to 8") with the customizer. The mount seats on the underside of an exposed rafter tail and gives the camera a flat, level mounting surface, so the camera hangs plumb from the eave.

How it mounts

• The rafter pocket is sized to your lumber: 1-1/2" for modern 2-by framing, or up to 4" in 1/16" steps for rough sawn and full-dimension rafters. Centering ridges locate the mount on the board. For a rafter wider than the mount body, choose which edge to align with the lumber (left, right, or a flat seat).
• Self-centering screw bores. Each mounting screw drives up into the rafter through a bore that is open from below, so nothing needs access from above the eave. The top of the bore is a cone that funnels the screw tip to the hole and centers it, and a thin sacrificial layer over the hole holds the screw upright until the driver engages. Drop the screw in, seat the bit, and drive: the screw stays put even with the mount, the driver, and the camera overhead on a ladder.
• The camera's cable pocket faces the house side of the rafter, so the microphone looks out from the eave and the cable runs up behind the bird block or into the eave.
• Extension is measured from the camera face to the rafter seat at the center of the mount.

Have a closed soffit instead of exposed rafters? The angled soffit mount for this camera is listed under Similar Items below.

Materials & Colors:

• White PETG
• Black PETG
• Carbon Fiber PETG

PETG is a tough, impact-resistant plastic with excellent moisture, chemical, and UV resistance for long-lasting real-world use.

3D printed (made to order) in the color you choose.